Bryant T6-PRH Instrukcja Obsługi Pobierz pdf (Strona 15)

8. Make sure 2--wire pigtail is attached to Display Module mounting base.

This should come attached from the factory. Attach two--wire pigtail to

the back of the Display Module via 2 pin, keyed connector.

9. Reattach Display Module body to mounting base by first setting on at top

of mounting base and then push bottom corners of Display Module to

snap into place. See Fig. 9.

A07169

Fig. 9 -- Attach Display to Backplate

10. Find suitable indoor mounting location for Equipment Control Module,

either near or on equipment. See Fig. 10.

IMPORTANT NOTE: Equipment Control Module should not be mounted

to duct work or below any other contro ls or equipment (i.e. humidistat,

humidifier, etc.).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 75 76

Brak uwag

Bryant T6-PRH Instrukcja Obsługi Strona 15