Bryant T6-PRH Instrukcja Obsługi Pobierz pdf (Strona 19)

A07219

Fig. 13 -- Equipment Control Module

5. Match and connect equipment wires to proper terminals of each connector

block.

6. Push any excess wire into wall and against Equipment Control Module.

Seal hole in wall to prevent air leaks. Leaks can af fect operation and cause

incorrect temperature and/or humidity measurement.

7. Remove 2--wire pigtail from thermostat mounting base and attach to

Equipment Control Module terminal block (terminals V+ and Vg). Attach

two-- wire pigtail to the back of the Display Module via 2 pin, keyed con-

nector .

8. Reattach Display Module body to Equipment Control Module by first

setting on at top and then push bottom corners to snap into place. See Fig.

14.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 75 76

Brak uwag

Bryant T6-PRH Instrukcja Obsługi Strona 19